Sloping Cross (0-11 degrees) for 42mm Galvanised Pipe D4VD03 and normally used between middle

and normally used between middle rail and uprights on sloping sites and often paired with type 153 or 155

Plantation grown finger jointed Radiata Pine that has been H3 treated (suitable for above ground use)

Its fixing holes are suitable for a wide range of common mechanical and chemical masonry anchors

balustrades or other structures

Sloping Cross (0-11 degrees) for 42mm Galvanised Pipe D4VD03 and normally used between middleWhere would you normally use this galvanised pipe fitting? The 156 Slope Cross (Middle Rail) is adjustable for slopes from 0 degree to 11 degree, and normally used between middle rail and uprights on sloping sites and often paired with type 153 or 155. The through tube (vertical in photo) cannot be joined within the fitting. What size pipe does it fit to? This fitting will work with galvanised pipe (tube) of an outside diameter of approximately 42mm.